Technical data

Configuration
Using the Boot Console Handler
3-4
Using the Boot Console Handler
Perform the following steps to enter and use the boot console user interface:
1 Shut down your application.
2 Press the Rst/Abt switch on the front panel to the Rst (reset) position.
The system pauses, resets, then displays a screen similar to:
PDC - Processor Dependent Code - Version 300.0 release 0 (c)
Copyright 1994, Hewlett-Packard Company, All rights
--------------------------------------------------------
128 Mbytes of memory configured. System Search started
Press [Esc] to discontinue the Auto Boot process
3 Press the Esc key to discontinue the autoboot process. The system displays a message
stating the Auto Boot Process has been aborted, and then displays the Main Menu, as
shown:
==== MAIN MENU ===============================
Key Operation
-- -----------------------------------------
1 Boot From a Device
2 Path Configuration
3 Mode Configuration
4 Interactive Testing
5 Firmware Information
6 Hardware Information
7 System Configuration
... .........................................
77 Reset the system
88 Change Mode
99 Restart Auto Boot
----------------------------------------------
Press Key, then press [Enter/Return]