Technical data

Field Replaceable Units
Removing and Replacing an HCRX Graphics Board
5-27
Figure 5-12 HCRX Board Fasteners
2 Remove the four DIN connector M2.5X12 screws from the bottom of the system board.
3 Remove the two small screws at each end of the graphic connector on the front panel.
4 Remove the HCRX board from the computer by lifting it straight up from the centered
connector.
Replacement
To replace an HCRX board, reverse the steps in the procedure for removing a board.
M2.5X12
screws
M2.5X6
screws
Front
Panel
screws