Technical data

Troubleshooting
Interactive Testing Menu
4-13
Interactive Testing Menu
Once in the Boot Console Handler Mode, at the Main Menu, select Interactive Tests. This
menu, shown below, allows a user to run selected tests and allows access to the debugger
environment. Table 4-2 lists the types of test you can run from the Interactive Test menu.
==== INTERACTIVE TESTING =====================
Key Operation
--- -----------------------------------------
1 CPU S.S.
2 HIL INIT
3 GRAPHICS 1 INIT
4 GRAPHICS 2 INIT
5 GRAPHICS 3 INIT
6 GRAPHICS 4 INIT
... .........................................
00 Previous Menu
44 Enter Debug Environment
77 Reset the System
----------------------------------------------
To run a test, Press Key, then press [Enter/Return]
When an interactive test is run, the pass/fail message appears at the bottom of the menu.
For more information and examples on Interactive Tests, see the section “Interactive Test
Menu” in this manual.
Table 4-2 Interactive Tests
Test Function
CPU S.S. Tests the CPU super scalar operations
HIL INIT Initializes and tests the HIL interface. This test support the
Model 748i VME system’s HP-HIL connector used with its
EISA converter board.
If this is the console keyboard, the test will not run, but will
report “passed”.
GRAPHICS n If the hardware is missing, the test reports as “passed.” If the
special graphics interface is the console, the test will not run, but
reports as “passed”.