Specifications

Removal and Replacement Procedures
SCSI Controller
To remove the component:
1. Power down the server. Refer to “System Power Down” in this chapter.
2. Remove the front bezel. Refer to “Front Bezel” in this chapter.
3. Remove the access panel. Refer to “Access Panel” in this chapter.
4. Remove the SCSI controller:
a. Disconnect the SCSI cable attached to the SCSI controller.
b. Remove the screw that secures the SCSI controller to the slot.
c. Slide the SCSI controller out of the slot.
IMPORTANT: Always install the SCSI controller in slot 1.
To replace the component, reverse the removal procedure.
2-32 HP ProLiant ML330 Generation 3 Server Maintenance and Service Guide