Specifications

Removal and Replacement Procedures
Removable Media Bay Devices
To remove the component:
1. Power down the server. Refer to “System Power Down” in this chapter.
2. Remove the front bezel. Refer to “Front Bezel” in this chapter.
3. Remove the access panel. Refer to “Access Panel” in this chapter.
4. Remove the air baffle, as needed to access cabling. Refer to “Air Baffle” in this chapter.
5. Disconnect any cabling attached to the drives in the compartment. Refer to “Cable
Routing Diagrams” in this chapter.
6. Remove the media bay drive tray. Refer to “Media Bay Drive Tray” in this chapter.
7. Remove the device from the tray:
a. Remove the screws from the bottom of the device.
b. Lift the device from the tray.
To replace the component, reverse the removal procedure.
2-28 HP ProLiant ML330 Generation 3 Server Maintenance and Service Guide