User's Manual

To launch HPSUM:
1. For Windows Server 2008 R2 wSP1 Standard operating system, click Start, and then select
All Programs>Pre-Install Features>HP Service Pack for ProLiant.
For Windows Server 2012 standard operating system, press button from the keyboard and
right click anywhere in the Start page, then click All Apps>Pre-Install Features>HP Service
Pack for ProLiant.
For Windows Server 2012 R2 Standard operating system, click Start, click on ↓ button and
then under Pre-Install Features, select HP Service Pack for ProLiant.
Follow the on-screen instructions when the setup program is launched. You might have to enter
user credentials during installation.
To manually launch HPSum:
• Navigate to the directory that holds HP SUM.
• Right click on HPSum.bat file and click Run as Administrator
For more information on how to manually launch HPSum, see HP Smart Update Manager
User Guide.
Configuring array controllers
If an array controller was purchased with the server, run the online ACU/HP SSA to set up the
remaining physical drives for use.
IMPORTANT: Microsoft® Internet Explorer is required to run the ACU. Internet Explorer is used
to interface with the array controller. For the page to display properly, the server IP address must
be included in the trusted sites list. Internet Explorer must be restarted after adding the IP address
to the trusted sites list for the settings to take effect.
To configure array controllers:
1. For Windows Server 2008 R2 wSP1 Standard operating system, click Start, and select All
Programs>HP System Tools>HP Smart Storage Administrator.
For Windows Server 2012 operating system, Press button from the keyboard and right
click anywhere in the Start page, then click All Apps>HP System Tool>HP Smart Storage
Administrator.
For Windows Server 2012 R2 Standard operating system, click Start, click on ↓ button, and
then click Apps > HP System Tool > HP Smart Storage Administrator.
2. Configure the remaining physical drives into logical drives, and run Disk Management to
partition and format the additional drive space.
For more information about using the ACU/HP SSA, see the http://www.hp.com/go/hpssa.
Using Management Agents
The Management Agents for servers are installed during the setup process. For more information
about the Management Agents, see the HP Insight Management Agents User Guide.
36 Post-installation tasks for HP ProLiant series servers