Implementing Microsoft® Windows Server® 2008 R2 Hyper-V™ and Microsoft Hyper-V Server 2008 R2

5. Select No-Execute Page-Protection, press Enter, and then select Enabled.

6. Select AMD Virtualization, press Enter, and then select Enabled.

7. Press the Esc key until you receive a prompt to press F10 to confirm exiting the RBSU. The server

will perform a restart.

Installing Microsoft Hyper-V Server 2008 R2

To install Microsoft Hyper-V Server 2008 R2, complete the following steps:

1. Make sure that the server has a DVD drive (either installed in the server or attached to the server)

- Or -

Boot the server into Microsoft Windows Preinstall Environment (Windows PE or WINPE) from a

USB key. It is possible to boot the target server from across a network using Windows Deployment

Services. For details on Booting WINPE, refer to the Windows Automated Installation Kit (WAIK).

NOTE

iLO virtual media requires a license key with ProLiant ML and DL servers

and, in certain circumstances, with ProLiant BL servers.

2. Place the Hyper-V Server 2008 R2 media into the DVD drive and boot the server from the DVD to

begin the installation.

3. Follow the on-screen instructions to complete the installation.