Implementing Microsoft® Windows Server® 2008 R2 Hyper-V™ and Microsoft Hyper-V Server 2008 R2

12. Select No-Execute Page-Protection, press Enter, and then select Enabled.

13. Select AMD Virtualization, press Enter, and then select Enabled.

14. Press the Esc key until you receive a prompt to press F10 to confirm exiting the RBSU. The server

will perform a restart.

Installing Windows Server 2008 R2

To install Windows Server 2008 R2 edition, complete the following steps:

1. Make sure that the server has a DVD drive (either installed in the server or attached to the server).

- Or -

Boot the server into Microsoft Windows Preinstall Environment (Windows PE or WINPE) from a

USB key. This is possible from across a network using Windows Deployment Services. For details

on Booting WINPE, refer to the Windows Automated Installation Kit.

NOTE

iLO virtual media requires a license key with ProLiant ML and DL servers

and in certain circumstances with ProLiant BL servers.

2. Place the Windows Server 2008 R2 media into the DVD drive and boot the server from the DVD

to begin the installation.

3. Follow the on-screen instructions to complete the installation.