Management Agents Events Reference

Event DescriptionEvent SeverityEvent ID
Generic trap for Critical or Fatal type E0 event from system firmware. Probable Cause:
This event is generated when a critical or fatal event has occurred as reported by
system firmware. The server is not operational and is in a state where it cannot
provide more details about the failure. To obtain more information, log into the
server's Management Processor Card and look at the event log for more details on
the failure. Recommended Action: Contact HP Support for best course of action. HP
may require a reboot, reconfiguration, or reflash of firmware. SNMP Trap: SystemFW
- 700 in HPIFP02TRAP.MIB.Error700
Voltage insufficient. Probable Cause: The input voltage for the system is not sufficient
for operation. Recommended Action: Check all boards, power supplies, and modules
that either supply or use this voltage rail. SNMP Trap: HPEnvironment - 704 in
HPIFP02TRAP.MIB.Warning704
Voltage reached critical level. Probable Cause: The voltage in the server has gone
outside the factory set range. A bad component, blown fuse, poorly seated module,
loose cable, or debris could be responsible for this failure. Recommended Action:
When this condition was detected the system should have been immediately
shutdown to avoid damage. Contact your HP support representative as soon as
possible to have the unit checked. Check all boards, power supplies, and modules
that either supply or use this voltage rail. SNMP Trap: HPEnvironment - 705 in
HPIFP02TRAP.MIB.Error705
Power Pod Voltage Fault. Probable Cause: The voltage in the server has gone outside
the factory set range. A bad component, blown fuse, poorly seated module, loose
cable, or debris could be responsible for this failure. Recommended Action: Check
all boards, power supplies, and modules that either supply or use this voltage rail.
SNMP Trap: HPEnvironment - 706 in HPIFP02TRAP.MIB.Error706
Voltage absent. Probable Cause: There is either a missing or failed power component.
This may be a normal message when a system is not loaded to capacity and power
components are purposefully left out of the system. Recommended Action: If this is
unexpected, then check all boards, power supplies, and modules that either supply
or use this voltage rail. SNMP Trap: HPEnvironment - 707 in HPIFP02TRAP.MIB.Warning707
Fan speed lags. Probable Cause: Possibly, the specified fan is beginning to lose
performance. Recommended Action: If these errors continue to be reported, the fan
should be replaced. SNMP Trap: HPFan - 710 in HPIFP02TRAP.MIB.Warning710
Power supply failure. Probable Cause: The system has detected that one of the power
supplies has failed. Recommended Action: The power cable has been disconnected.
Reconnect, or The power supply has failed. Contact your HP support representative
to check the power supply. SNMP Trap: RedundantPower - 720 in HPIFP02TRAP.MIB.Warning720
Power supply AC lost. Probable Cause: The power supply has lost its A/C source.
The power supply is not connected to a working A/C power source. Recommended
Action: Verify that the plug is connected to the power supply, and to a working
power source. SNMP Trap: RedundantPower - 722 in HPIFP02TRAP.MIB.Warning722
Power failure in power supply. Probable Cause: Indicates a failure with the AC power
source that is connected to one of the redundant power supply units. Recommended
Action: Check the power cord or source voltage. SNMP Trap: hpPowerSupply - 726
in HPIFP02TRAP.MIB.Error726
Voltage reached critical level. Probable Cause: The voltage in the server has gone
outside the factory set range. A bad component, blown fuse, poorly seated module,
loose cable, or debris could be responsible for this failure. Recommended Action:
Check all boards, power supplies, and modules that either supply or use this voltage
rail. SNMP Trap: HPEnvironment - 728 in HPIFP02TRAP.MIB.Error728
System shut-down or reset caused by sensor reading. Probable Cause: A sensor
reading in the system was determined to be non-recoverable and the system was
shut down or reset. Recommended Action: Read the system logs to find which sensor
was out of range. SNMP Trap: SystemHW - 729 in HPIFP02TRAP.MIB.Error729
Platform Agent Events 9