Management Agents Events Reference

Event DescriptionEvent SeverityEvent ID
The Dillon IPR is not cleared after a MAX_RD_CLR_IPR_TRIES on a cell. Probable
Cause: The PDH FPGA IPR is not cleared after a MAX_RD_CLR_IPR_TRIES on a
cell. Recommended Action: Contact HP Support personnel to troubleshoot the
problem. SNMP Trap: hpevtPdhIprNotClearedOnCell - 8761 in HPIFPTRAP.MIB.Warning8761
Indicated the Dillon IPR is not cleared after a number of PDC attempts. Probable
Cause: PDH FPGA IPR is not cleared after a number of PDC attempts. Recommended
Action: Contact HP Support personnel to troubleshoot the problem. SNMP Trap:
hpevtPdhIprClearAttempts - 8762 in HPIFPTRAP.MIB.Warning8762
Failed accessing the core cell RTC while synchronizing the OLA cell's RTC. Probable
Cause: Core cell data could not be accessed/fabric connections went bad.
Recommended Action: Collect IPMI events and contact HP Support. SNMP Trap:
hpevtBootOlaUpdateRtcFailedExistingCell - 8763 in HPIFPTRAP.MIB.Error8763
The echelon given in the data field is not fully populated. Probable Cause: the specified
echelon is not fully populated and is not usable. Recommended Action: add or replace
dimms in the specified echelon SNMP Trap: hpevtMemIncompleteEchelon - 8768 in
HPIFPTRAP.MIB.Warning8768
Attempted to read the port state from an illegal port number. Probable Cause: An
invalid port number has been provided. The port number will be converted to an
internal port and processing should continue. Recommended Action: Contact HP
Support personnel to analyze the fabric. SNMP Trap:
hpevtFabricRdPortStatePortInvalid - 8771 in HPIFPTRAP.MIB.Warning8771
Attempted to write the port state for an illegal port. Probable Cause: An invalid port
number has been provided. The port number will be converted to an internal port
and processing should continue. Recommended Action: Contact HP Support personnel
to analyze the fabric. SNMP Trap: hpevtFabricWrPortStatePortInvalid - 8772 in
HPIFPTRAP.MIB.Warning8772
The main backplane is reporting the LPM status as fault. Probable Cause: Many
possible causes, repair / replace the appropriate part. SNMP Trap:
hpevtMainBpLpmFlt - 8784 in HPIFPTRAP.MIB.Warning8784
The IO backplane is reporting a LPM status as fault. Probable Cause: Service / replace
the appropriate part of, or the entire backplane. SNMP Trap: hpevtIoBpLpmFlt - 8787
in HPIFPTRAP.MIB.Warning8787
System firmware was unable to default the complex profile. Probable Cause: Needed
information could not be obtained. Reset the MP. SNMP Trap:
hpevtCmplxProfileInitFailed - 8797 in HPIFPTRAP.MIB.Error8797
Firmware could not set Pal Proc features. Probable Cause: FW MCA code uses this
PAL_SET_PROC_FEATURES to escalate future MCA to BINIT. This event id when
emitted during an MCA processing means that any subsequent global MCA would
not cause all the processors in the PD to MCA again. SNMP Trap:
hpevtPalSetProcFeaturesFailed - 8798 in HPIFPTRAP.MIB.Warning8798
Means that the error log space in the Nvram has not been allocated. Probable Cause:
This happens because of the NVRAM is full with unconsumed error logs. Clear the
error logs. SNMP Trap: hpevtActiveLogNotFound - 8806 in HPIFPTRAP.MIB.Warning8806
This indicates the maximum number of logs for the event. Probable Cause: This
shouldn't be occur. But in case it does than clear the error logs of this event type from
the nvram. SNMP Trap: hpevtReachedMaxErrorLogs - 8807 in HPIFPTRAP.MIB.Warning8807
On Line Delete operation was begun but firmware couldn't find a deleteable cell.
Probable Cause: This can occur if the OS has not returned all the CPUs to firmware
or if a cell is not marked correctly in the complex profile to allow its deletion. SNMP
Trap: hpevtOldNoCellToDelete - 8814 in HPIFPTRAP.MIB.Warning8814
The bulk power system is above its current capacity. Probable Cause: N/A SNMP
Trap: hpevtBpsOvercurrent - 8817 in HPIFPTRAP.MIB.Error8817
54 Management Agents Event Tables