Installation (Smart Setup) Guide, Windows Server 2008, v6.2

Figure 3-15 SNMP traps tab
5. In the Community name field, if a community name exists, select it; if not, enter a community
name and click Add to List.
The default community string for HP Insight Manager is public. If you enter a different
community string here, enter the same string on the management console that is responsible
for the system. HP recommends not using the string public because it is the default value,
commonly used, and can present a security risk.
6. Under the Traps Destinations list, click Add. The SNMP Service Configuration window
appears.
Figure 3-16 SNMP service configuration
7. In the Host name, IP or IPX Address field, enter the IP address of the management console.
This address identifies the management console to receive the alert when the server agents
detect a significant event.
8. Add 127.0.0.1 as a trap destination if it is not already listed. You must do this to enable the
loopback service.
9. Click Add and then OK.
Configure System Management Homepage
This section describes the configuration of SMH on Integrity servers. After configuring SMH
you can use Appendix D “SMH and the WBEM Providers/SNMP Management Agents” for an
overview of how to use it to administer your system locally or remotely.
68 Installing and Configuring the Management Tools