Installation (Smart Setup) Guide, Windows Server 2008, v6.1

NOTE: You might not be able to use EBSU to flash the firmware of some devices. You
cannot flash the firmware if the installed version is the same or higher than the version on
the Smart Setup media. Also, you cannot use EBSU to flash the Management Processor (MP)
firmware. You must download the latest MP firmware from the HP Integrity support site
and flash it separately. See: http://www.hp.com/support/itaniumservers/.
8. EBSU displays the partition disk screen. Select ESP + HPSP + MSR or ESP Only. HP
recommends the default — ESP + HPSP + MSR — as a way to simplify the maintenance of
your server.
Figure 2-3 EBSU Partition Disk screen
9. EBSU displays an install options screen. Accept the default options to install the Drive
Explorer utility (for browsing a drive in EFI) and offline diagnostic tools (from the HP
Integrity Offline Diagnostics CD) in the HPSP partition. Also specify which version of the
Windows OS Installer to launch (in this case: Windows Server 2008). Then select Next and
press Enter.
Figure 2-4 EBSU Install Options screen
Install from a Headless Console 31