Installation Guide, Windows Server 2008 SP2 v7.0

NOTE: You might not be able to use EBSU to flash the firmware of some devices. You
cannot flash the firmware if the installed version is the same or higher than the version on
the Smart Setup media.
8. EBSU displays the partition disk screen. Select ESP + HPSP + MSR or ESP Only. HP
recommends the default (ESP + HPSP + MSR) as a way to simplify the maintenance of your
server.
Figure 2-16 EBSU Partition Disk Screen
9. EBSU displays an install options screen. Accept the default options to install the Drive
Explorer utility (for browsing a drive in EFI) and offline diagnostic tools (from the HP
Integrity Offline Diagnostics CD) in the HPSP partition. Also, specify which version of the
Windows OS Installer to launch (in this case, Windows Server 2008 SP2). Then select Next
and press Enter.
Install from a GUI Console 39