Installation Guide, Windows Server 2008 SP2 on HP Integrity Servers v7.1 (T2369-90031, March 2011)

NOTE: The steps that follow apply to users of Microsoft Windows OS media only. If you
are using HP Reinstall media, follow the next prompt to load Windows, then go to Step 7
in “Load the System Image to the Boot Disk” (page 48) and continue the rest of your
installation from there.
7. EBSU displays the firmware update screen, listing each device, its installed firmware version,
and the firmware version on the Smart Setup media. Select the firmware devices you want
to update. To continue, select Next and press Enter.
Figure 2-17 EBSU Firmware Update Screen
NOTE: You might not be able to use EBSU to flash the firmware of some devices. You
cannot flash the firmware if the installed version is the same or higher than the version on
the Smart Setup media.
8. EBSU displays the partition disk screen. Select ESP + HPSP + MSR or ESP Only. HP
recommends the default (ESP + HPSP + MSR) as a way to simplify the maintenance of your
server.
40 Installing the OS