HP Integrity Windows Server 2008 R2 and Windows Server 2008 SP2 Hardware Administrator's Guide v6.5

— Using the SO command, change individual users.
— Using the DC command, select Reset Security Configuration.
— Reset forgotten passwords by pressing the MP reset button on the back panel
of the HP server. After the MP reboots, the local console terminal displays
a message for 5 seconds. Responding to this message in time allows a local
user to reset the password.
NOTE: All user information (for example, logins and passwords) is erased in
methods 2 and 3.
DF
Displays FRUID information. This command displays FRUID information from the
BMC for FRU devices. Information provided includes serial number, part number,
model designation, name and version number, and manufacturer.
DI
Disconnects remote/modem or LAN/WEB console. This command disconnects (hangs
up) the remote/modem or LAN/WEB users from the MP. It does not disable the ports.
The remote console is no longer mirrored.
FW
Activates MP firmware upgrade mode. This command is available from either the
LAN or a local serial port. This command activates firmware upgrade mode, which
loads new firmware through the MP LAN by FTP (which must be operational). An
MP reset is generated after the upgrade is complete.
HE
Displays help for menu or command. This command displays the MP hardware and
firmware version identity, and the date and time of firmware generation. If executed
from the MP Main Menu, this command displays general information about the MP
and those commands displayed in the MP Main Menu. If executed in command mode,
this command displays a list of command interface commands available to you. It
also displays detailed help information in response to a topic or command at the help
prompt.
ID
Displays and modifies the following system information:
• SNMP contact information
• SNMP server information
• SPU host name
IT
Inactivity Timeout settings. The maximum session inactivity timeout is 1,440 minutes.
The default is 60 minutes. This timeout prevents sessions from being inadvertently
left open. You can start a session with the SE command. An open session can prevent
users from logging into the MP through a port and can also prevent system
applications from initiating an outbound connection.
The maximum MP inactivity timeout is 1,440 minutes. The default is 5 minutes. This
timeout prevents a user from inadvertently keeping the MP locked in an MP command
interface mode, and preventing other users from looking at the console output. You
cannot deactivate the MP command interface inactivity timeout
The flow control timeout is 0 to 60 minutes. If set to 0, no timeout is applied. This
timeout prevents mirrored flow control from blocking other ports when inactive.
LC
LAN configuration (IP address and so on). This command displays and allows
modification of the following LAN configuration parameters:
• MP IP address
• MP host name
• Subnet mask
• Gateway address
MP Commands 13