Failover Cluster Installation and Configuration Guide, Windows Server 2008 SP2 and Windows Server 2008 R2 SP1

ManualsBrandsHP ManualsSoftwareMicrosoft Windows Server 2008 for Itanium-based Systems

14. Go to the next section (“Troubleshooting the Cluster” (page 29)) for information about

troubleshooting problems with your failover cluster.

Gathering Required Installation Information

Use Table 2-1 to record the input parameters you will need to install and configure the cluster.

Record the information in the Value column next to each description.

Table 2-1 Installation and Configuration Input

Input ValueInput Description

Node 2:Node 1:Node names

(Microsoft Windows Server

2008 supports up to eight

nodes per cluster)

Node 4:Node 3:

Node 6:Node 5:

Node 8:Node 7:

Domain name:Domain name, DNS IP

address, and subnet mask for

the domain controller:

DNS IP:

Domain controller subnet mask:

Cluster name:Cluster management

network name and IP

address:

Cluster IP:

Node 1 team:Node 1 Public-1:Public network connection

IP addresses and team IP

address for each node:

Node 1 Public-2:

Node 2 team:Node 2 Public-1:

Node 2 Public-2:

Node 3 team:Node 3 Public-1:

Node 3 Public-2:

Node 4 team:Node 4 Public-1:

Node 4 Public-2:

Node 5 team:Node 5 Public-1:

Node 5 Public-2:

Node 6 team:Node 6 Public-1:

Node 6 Public-2:

Node 7 team:Node 7 Public-1:

Node 7 Public-2:

Node 8 team:Node 8 Public-1:

Node 8 Public-2:

Subnet mask:Private network connection

(cluster heartbeat) subnet

mask and IP address for each

node:

Node 2:Node 1:

Node 4:Node 3:

Node 6:Node 5:

Node 8:Node 7:

Gathering Required Installation Information 19