Array Configuration Utility User Guide

Scripting in ACU 42
Message Comment or explanation (if not self-explanatory)
Invalid read cache/write cache
ratio
The specified cache ratio is not supported by either the controller or
the current controller configuration.
Invalid rebuild priority --
Invalid Sectors
The specified Max Boot setting is invalid or is not supported with the
current configuration.
Invalid Size
The specified size is invalid or is not possible with the current
configuration.
Invalid Spare
The spare drive listed for the array is not a valid spare drive, or it is
a drive that is not capable of being placed on the array as a spare.
Invalid SSP adapter ID --
Invalid SSP state --
Invalid stripe size
The specified stripe size is either invalid, not supported with the
current RAID level, or not supported with the current configuration.
Invalid SurfaceScanDelay --
License key is not a controller
feature license key
The entered license key is for a feature that the controller does not
support.
Logical drive not specified
Some commands require a logical drive, but no logical drive is
specified in the script file.
More than one (text) command
cannot exist in the same section
The specified command should be used only once per section.
New array ID already exists
This error occurs in Configure mode when the array ID in the script
file already exists in the configuration. You can only use Configure
mode to create new arrays.
New array ID does not match the
next available array ID
The array ID that you specified in the script file does not match the
ID of the newly created array. For example, the script generates this
error if you have only an array A and the script file specifies
creation of array C (missing array B).
New logical drive ID already
exists
This error occurs in Configure mode when the logical drive ID in the
script file already exists in the configuration. You can only use
Configure mode to create new logical drives.
New logical drive ID does not
match the next available logical
drive ID
The logical drive ID that you specified in the script file does not
match the ID of the newly created logical drive. For example, the
script generates this error if you have only logical drive 1 and the
script file specifies creation of logical drive 3 (missing logical drive
2). This error can occur when using an input file with logical drive
numbers that are not sequential. In this case, change the logical
drive numbers so that they are sequential in the input file.
No controllers detected
This error applies to input mode only. If no controllers are detected
in capture mode, the capture file is empty.
Slot information is not available
You cannot run Input mode on internal controllers that do not have
slot information online. For Microsoft®
Windows®, this means that
you must load the System Management Driver.
Too many coinciding expansion,
migration, or extension operations
ACU does not support multiple simultaneous expansions, migrations,
or extensions without saving the configuration between operations.
Limit the number of such configuration changes in this script.
(text) is not an HBA command
A command found in the HBA section is not a valid command for
this section.