Management Agents Events Reference

Event DescriptionEvent SeverityEvent ID
Failed disabling the XIN link for a single cell model. Probable Cause: Fabric Access
Error. Recommended Action: Contact HP Support personnel to analyze the fabric.
SNMP Trap: hpevtFabricInitCcLinkDisableErr - 8926 in HPIFPTRAP.MIB.Warning8926
Error while getting the XBC Semaphore. Probable Cause: Most likely a hardware
problem, but confirm the cause by looking at the return status. Recommended Action:
Check XBC, Backplane, Flex Cables, Contact HP Support Personnel for further
troubleshooting. SNMP Trap: hpevtFabricSetPortStateGetSm4Err - 8930 in
HPIFPTRAP.MIB.Error8930
Error releasing the XBC Semaphore. Probable Cause: Fabric Access problem. Either
an error reading the hardware or XBC Key contention. Recommended Action: Look
for additional chassis codes to provide detail. Check XBC, Backplane, Flex Cables,
Contact HP Support Personnel. SNMP Trap: hpevtFabricSetPortStateRlsSm4Err -
8931 in HPIFPTRAP.MIB.Warning8931
Unexpected fabric firmware error. Probable Cause: An unanticipated error occurred.
Contact HP Support personnel to analyze the IPMI FPL log. SNMP Trap:
hpevtFabricAssertFabricErr - 8936 in HPIFPTRAP.MIB.Warning8936
The CC's XIN link was found to be already initialized. Probable Cause: Firmware
problem. Contact HP Support Personnel. SNMP Trap: hpevtFabricXinLinkAlreadyInit
- 8939 in HPIFPTRAP.MIB.Warning8939
Cell has been disabled by the PDHC because no CPU modules were found. Probable
Cause: No CPU modules are installed. Recommended Action: Install CPU modules
on the Cell. SNMP Trap: hpevtNoCpuModulesFoundByPdhc - 8940 in
HPIFPTRAP.MIB.Error8940
Cell has been disabled by PDHC FW because the CPU modules are not compatible.
Probable Cause: At least one of the installed CPU modules are incompatible with at
least one other CPU module. Recommended Action: Contact HP support personnel
to troubleshoot the CPU modules on the Cell. SNMP Trap:
hpevtCpuModCompatMismatch - 8941 in HPIFPTRAP.MIB.Error8941
Cell has been disabled because of invalid data in a CPU module Scratch EEPROM.
Probable Cause: The CPU module is not an HP CPU module, or the FRUID data for
this CPU module has not been programmed. Recommended Action: Contact HP
support personnel to troubleshoot the CPU module. SNMP Trap:
hpevtBadCpuModScratchCksum - 8942 in HPIFPTRAP.MIB.Error8942
The Cell Battery voltage level low warning. Probable Cause: The Cell Battery is low.
Recommended Action: It needed to be replaced. SNMP Trap:
hpevtPdhBatteryLowWarning - 8954 in HPIFPTRAP.MIB.Warning8954
Error while copying the XBC routing to the local port. Probable Cause: Error accessing
XBC CSRs. Recommended Action: Contact HP Support personnel to analyze the
fabric. SNMP Trap: hpevtFabricRouteXbcCopyRoutingErr - 8959 in HPIFPTRAP.MIB.Error8959
A read after write of a XBC CSR failed. Probable Cause: Fabric Access Error, XBC
Key Disabled. Check XBC, links, backplane, Contact HP Support Personnel for further
troubleshooting. SNMP Trap: hpevtFabricCopyRdBackFailed - 8960 in
HPIFPTRAP.MIB.Error8960
Couldn't release the Semaphore while writing routing states. Probable Cause: Fabric
Access Error. Check XBC, Check links. SNMP Trap:
hpevtFabricRtgCompleteSm4RlsErr - 8962 in HPIFPTRAP.MIB.Warning8962
Couldn't write the XBC's forward progress register. Probable Cause: Fabric Access
Error. Couldn't write this XBC. Recommended Action: Contact HP Support personnel
to analyze the fabric. SNMP Trap: hpevtFabricRtgCompleteWrFwdPrgErr - 8964 in
HPIFPTRAP.MIB.Error8964
Couldn't access the XBC semaphore registers. Probable Cause: Fabric Access Error.
Couldn't read or write this XBC. Recommended Action: Contact HP Support personnel
to analyze the fabric. SNMP Trap: hpevtFabricRtgCompleteSm4AccessErr - 8965 in
HPIFPTRAP.MIB.Error8965
Platform Agent Events 57