Management Agents Events Reference

Event DescriptionEvent SeverityEvent ID
The current cell detected incompatible CPUs on another cell. Probable Cause: Mixed
CPU types are installed in the same partition. Remove them. SNMP Trap:
hpevtPdIncompatibleCpuTypes - 5365 in HPIFPTRAP.MIB.Error5365
Current cell was too slow creating the local rendezvous set. Probable Cause: Cell too
slow. Could be bad hardware. Check for other errors and reset. Recommended Action:
If assistance is required, contact the HP Support Center. SNMP Trap:
hpevtPdCellLateLocalRendezSet - 5366 in HPIFPTRAP.MIB.Error5366
Reporting cell was not included in the global cell set. Probable Cause: Fabric problem,
Connection problem or timing problem. Reset the PD. SNMP Trap:
hpevtCellNotInGlobalSet - 5376 in HPIFPTRAP.MIB.Error5376
No Core Cell can be selected in the PD. Probable Cause: No cells have a functioning
core IO card. Add a core IO card to a cell in the PD and reset. SNMP Trap:
hpevtNoViableCoreCellInPd - 5380 in HPIFPTRAP.MIB.Error5380
Firmware was unable to notify utilities of the core cell number. Probable Cause:
Communication with utilities is broken. Check for earlier errors or NVRAM problems.
SNMP Trap: hpevtErrorPromotingCoreCell - 5383 in HPIFPTRAP.MIB.Error5383
Fabric code unable to find a needed service provider. Probable Cause: The registry
is corrupt or the ROM is incomplete. SNMP Trap: hpevtFabricNoServiceProviders -
5403 in HPIFPTRAP.MIB.Error5403
Error in a fabric Port. Probable Cause: Reset. SNMP Trap: hpevtFabricPortError -
5404 in HPIFPTRAP.MIB.Warning5404
Parity error detected on read from fabric. Probable Cause: Hardware problem. Check
connections and reset. SNMP Trap: hpevtFabricReadError - 5405 in HPIFPTRAP.MIB.Warning5405
Error writing to Fabric. Probable Cause: Bad hardware. SNMP Trap:
hpevtFabricWriteError - 5406 in HPIFPTRAP.MIB.Warning5406
Crossbar slices are out of rev with each other. Probable Cause: Bad hardware
configuration, different revisions of crossbars are installed. Recommended Action:
Check crossbar revisions and ensure all installed crossbar revisions are the same.
Replace the crossbar that is not in rev with the others. SNMP Trap:
hpevtXbcSlicesHwVersionDiffer - 5407 in HPIFPTRAP.MIB.Error5407
Crossbar slices are configured poorly. Probable Cause: Fatal configuration.
Reconfigure the hardware. SNMP Trap: hpevtXbcSlicesInDiffLocation - 5408 in
HPIFPTRAP.MIB.Error5408
A CPU has taken over for the monarch CPU. Probable Cause: The previous monarch
may be suspect. SNMP Trap: hpevtMonarchTakeover - 5411 in HPIFPTRAP.MIB.Error5411
Sram cannot be used on the cell. Probable Cause: SRAM cannot be located or used
on the cell board. Replace the cell board. SNMP Trap: hpevtDeadSram - 5416 in
HPIFPTRAP.MIB.Error5416
The dillon hardware cannot be located. Probable Cause: ROM is corrupt. Replace
the rom or reprogram flash. SNMP Trap: hpevtDeadDillon - 5417 in HPIFPTRAP.MIB.Error5417
A required piece of PDH bus hardware cannot be contacted. Probable Cause: Verify
all connections of PDH bus components or replace the cell board. SNMP Trap:
hpevtDeadPdhHw - 5418 in HPIFPTRAP.MIB.Error5418
Error: PCI Buses are configured for multiple speeds. Probable Cause: A PCI card is
configured with mixed speeds. Recommended Action: Correct the configuration
problem. SNMP Trap: hpevtIoPciBusMixedSpeeds - 5419 in HPIFPTRAP.MIB.Warning5419
The bus depth was exceeded during IO probing. Probable Cause: Too many PCI
bridge cards are configured in single PCI segment mode. Recommended Action:
Reconfigure PCI cards and remove some of the bridge devices. SNMP Trap:
hpevtIoPciBusDepthExceeded - 5420 in HPIFPTRAP.MIB.Error5420
Platform Agent Events 23