Installation (Smart Setup) Guide, Windows Server 2003, v6.2

Figure 3-10 Adding a new user
7. From the Receiver type drop-down list, select the email recipient type.
8. Click OK to return to the recipient information window.
9. Select a user name and click Edit to edit user properties, or select a user name and click
Delete to remove a user.
10. Click Events to display the Event Selection window. A screen similar to the following
appears.
Figure 3-11 Event selection window
11. Use the Severity and Source filter fields to view selected events only. The event severity
levels, source, and message are not user-configurable.
12. Click the check box to enable an event or disable email notification for an event.
13. Click Use Default to load the current default event notification settings.
14. Click Set Default to set and save the current notification settings as the default values.
15. Click OK when you are done to return to the Event Recipient Information window.
16. Click Finish to close the window.
Set the SNMP Data Collection Interval
Active agents poll server devices at preset intervals, collecting management SNMP data.
To set the agent SNMP data collection interval, complete the following steps:
Configure the WBEM Providers (or SNMP Management Agents) 57