Installation (Smart Setup) Guide, Windows Server 2003, v5.1

3. Select a time interval for SNMP data collection from the Data Collection Interval list box.
4. Click the Send Test Trap button (available only if the HP host agent is active) to send a test
trap.
5. Click Clear All Thresholds to clear all current SNMP trap threshold values.
6. Click OK.
NOTE: Windows Server 2003 on the HP Integrity server does not support the following
SNMP operations:
• Enable Remote Reboot
• Enable the Application Exception Trap
• Disable Telnet Detection
• Disable Rack Infrastructure Traps
Monitoring server processes
Use the Process Monitor tab to set up SNMP traps generated when a process starts, stops, or
both.
To enable agent process monitoring, complete the following steps:
1. Open the Windows Control Panel and select Start Menu > Control Panel > HP Insight
Management Agents. The Management Agents for Servers Version Number window
appears.
2. Click the Process Monitor tab.
Figure 3-10 Process Monitor tab
This tab displays all currently active (running) server processes. The Monitor Option column
displays the current monitoring status for each process listed.
3. Select the process you want to change the monitoring status for.
4. Change monitoring status by clicking one of these radio buttons:
• None — No SNMP traps are generated for this process.
• Start — An SNMP trap is generated when this process starts.
• Stop — An SNMP trap is generated when this process stops.
• Start & Stop — An SNMP trap is generated when this process starts or stops.
• Add — Add a new process to the monitor. Enter the name of the new process, then
click Apply to add the process.
• Delete — Highlight a process in the list, and select Delete to delete the process.
5. Click Add to add a new process, then enter the name of the process.
6. Click Delete to delete a process selected from the list.
Installing the management agents 59