Manualshelf

Installation (Smart Setup) Guide, Windows Server 2003, v5.1

ManualsBrandsHP ManualsSoftwareMicrosoft Windows Server 2003 for Itanium-based Systems
41424344454647484950
1. Use HyperTerminal or PuTTY to log in to the MP.
2. Enter the CO command go to the SAC prompt.
3. At the SAC> prompt, enter the I command to specify the network number, IP address, and
subnet mask. For example:
I<network#><IPaddress><subnet mask>.
Set up and run a Remote Desktop Connection
The remote administration mode is enabled by default on Windows Server 2003 if you use the
HP Reinstall media. If you install or reinstall using Microsoft OS media, the Remote Desktop
functionality is disabled. Users must have unique user names. Windows does not permit two
users with the same name to log on simultaneously.
To set up a remote desktop connection from a GUI console, complete the following steps:
1. Right-click the My Computer icon and click Properties.
2. On the Remote tab, select Enable Remote Desktop on this computer.
3. Click OK.
4. On the Control Panel, double-click Windows Firewall.
5. Go to the Exceptions tab, check Remote Desktop, and click OK.
To set up a remote desktop connection from a headless server, complete the following steps:
1. Go to the SAC console.
2. At the SAC> prompt, enter cmd.
3. Press Esc+Tab to enter the Command Prompt console (this requires logging in as
Administrator).
4. Enter the following command from the Windows command prompt:
reg add "HKLM\System\CurrentControlSet\Control\Terminal Server" /v
fDenyTSConnections /t REG_DWORD /d 0 /f
To run Remote Desktop Connection, complete the following steps:
1. Click Start > Programs > Accessories > Communications > Remote Desktop
Connection.
2. Click the Computer drop-down list.
3. Select Browse for more.
4. Select the HP Integrity server with which you want to establish a connection.
5. Click OK.
6. Click Connect.
7. Log in to the remote server. Windows displays the remote server desktop.
Updating firmware, drivers, and software
To update your system after installing the OS, install the Integrity Support Pack from the HP
Smart Setup CD.
IMPORTANT: HP Customer Engineers must perform firmware updates for Superdome, rx8620,
and rx7620 servers in compliance with the support agreement.
You must install the Integrity Support Pack if you did not use the HP Reinstallation media to
install the OS.
Updating firmware, drivers, and software 43