HP Integrity Virtual Machines Installation, Configuration, and Administration

Loading device drivers
EFI Boot Manager ver 1.10 [14.62] [Build: Thu Jun 8 12:30:44 2006]
Please select a boot option
Windows Server 2003, Enterprise
EFI Shell [Built-in]
Boot option maintenance menu
Use ^ and v to change option(s). Use Enter to select an option
Default boot selection will be booted in 30 seconds
Starting: Windows Server 2003, Enterprise
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Starting Windows...
7. When the Windows SAC> prompt says EVENT:, the CMD command is available. Press the
Escape key and quickly press the TAB key, then press Enter to go to the following command
prompt:
Computer is booting,
SAC started and initialized.
Use the "ch -?" command for information about using channels.
Use the "?" command for general help.
SAC>...
EVENT: A new channel has been created. Use "ch -?" for channel help.
Channel: Unattended Setup Channel
SAC>
EVENT: The CMD command is now available.
SAC>
SAC>
END-USER LICENSE AGREEMENT FOR MICROSOFT SOFTWARE
MICROSOFT WINDOWS SERVER 2003, STANDARD EDITION WITH SERVICE PACK 1
MICROSOFT WINDOWS SERVER 2003, ENTERPRISE EDITION WITH SERVICE PACK 1
IMPORTANT-READ CAREFULLY: This end user license agreement ('EULA') is a legal
agreement between you (either an individual or a single legal entity) and the
manufacturer ('Manufacturer') of the computer system ('Server') with which you
acquired the Press F8 to accept or ESC to decline the EULA.
Press PAGE DOWN for next page.
To accept the EULA, press the Escape key, then 8, which emulates the F8 function key.
8. In response to the following prompt, enter the product key, including the dashes:
Type the Product Key below in the form
XXXXX-XXXXX-XXXXX-XXXXX-XXXXX
Product ID: XXXXX-XXXXX-XXXXX-XXXXX-XXXXX
(The 25–character product key appears on the lower section of your Certificate of
Authenticity.)
9. At the following prompt, enter the administrator password and press Enter:
Enter the password that will be used for the Administrator
Account on this machine. This password must not be blank.
Administrator Password:*******
Please re-enter the Administrator password.
Password Confirmation:*******
Setup will now proceed in an automated fashion.
10. Use ESC-TAB to cycle through screens until you see the one running the installation script.
The system boots to the Windows operating system.
Use ESC-TAB to go back to the SAC> prompt.
11. Obtain the guest's IP address by entering the i command to the SAC> prompt.
Use the Remote Desktop Connection from a PC to connect to that IP address and log in as
Administrator. The Support Pack completes installation:
5.2 Installing Windows Guests 53