HP Integrity Servers with Microsoft Windows Server 2003 Release Notes v6.1

Unset the Administrator password.•
• Run EBSU from the EFI Shell instead of from the EFI Boot Manager. The
EFI Shell can unblock the MPS Setting.
EBSU fails when flashing an Emulex 4 Gb HBA
Issue EBSU cannot flash the Emulex 4 Gb Host Bus Adapter (HBA) to the latest
firmware and EFI version, if the current EFI Driver flashed to the Emulex 4 Gb
controller is version 5.02A1.
Servers All Integrity
Workaround Exit EBSU.1.
2. Unload all Emulex drivers using the EFI shell unload command.
3. Run EBSU again.
ESBU can lose mapping of drives connected to QLogic controllers
Issue In some cases, EBSU may lose the mapping of disk drives attached to Qlogic
controllers.
Servers All Integrity
Workaround Use "Maintain Firmware" to flash the QLogic controller to the latest firmware.
After reboot the system, EBSU detects and configures the disk drives attached
to the QLogic controller.
Express Setup fails when launched from EBSU
Issue The OS installer fails when launched by EBSU if the DVD drive is attached to
a U320 controller.
Servers All Integrity
Workaround Exit EBSU.1.
2. Put the OS media in the DVD drive.
3. From the EFI Shell, issue the reconnect -r command followed by the
map -r command.
4. Run the OS installer.
Fibre Channel
Installation causes MSA 1500 driver to be flagged
Issue
A yellow exclamation mark (!) might be displayed for the HP StorageWorks
1000/MSA 1500 event notification driver after installing the Windows Server
2003 SP2 operating system using the 5.2 release reinstall media.
Servers All Integrity
Workaround Using the Release 5.2 HP Smart Setup Media (SSM) CD, do one of the following:
• Install the Support Pack (recommended).
• Install HP StorageWorks MSA1000/MSA1500 Event Notification Driver
component.
Target LUN and boot controller WWN not visible in a VC environment
Issue When installing to storage attached to an Emulex LPe1105 mezzanine controller
(403621-B21) in a Virtual Connect (VC) environment through a Brocade switch,
the target LUN is not visible and the WWN for the boot controller is not visible
in the zone in the switch administrative tool.
Servers HP Integrity BL860c Server Blade and BL870c Server Blade
22 Release 6.1 Overview