AD144A PCI-X 10 Gigabit Ethernet NIC Installation Guide

Hardware and Software Installation Procedure

Step 3: Connect the card to the network

If you are using Jumbo Ethernet frames, ensure that:

— all end stations on a given LAN have the same maximum transmission unit (MTU) setting;

— intermediate stations such as switch ports in your LAN have an MTU equal to or greater than the end

station’s MTU.

• Ensure power cable is connected to system. Power up the system.

NOTE To obtain updates to driver xena64.sys (version 2.0.15.0) check the HP Driver Support site

on http://www.hp.com/support/itaniumservers.