Setup and Install

Addressing subtab
Figure 3-22 Addressing subtab on the Device Configuration tab set
1
2
3
4
5
6
Table 3-15 Addressing subtab — Configure Devices tab set
Callout Component Description
1 Enable Network
Contacts (use
LDAP server)
Click to select Enable Network Contacts (use LDAP server) check box, and
then follow the steps below.
2 Network Directory
Server (LDAP)
(Step 1)
Use the following controls to designate the LDAP server.
●
Type the hostname or IP address in theLDAP Server Address text box or
click AutoFind to have DSS find the LDAP server address.
●
Click to select the Use a secure connection (SSL) check box.
●
Type the port number in the Port text box.
3 Server
Authentication
Requirements
(Step 2)
Click to select one of the following options.
●
Server does not require authentication.
●
Server requires authentication.
82 Chapter 3 Installation and configuration ENWW