Setup and Install

If you select anything other than HP Digital Sending Service as the Authentication Agent for
any feature, you will need to set up the authentication in the Embedded Web Server or Web Jet
Admin.
6. Depending on the Authentication Method you selected on the Authentication Settings page, you
can provide certain default user credential information.
●
If you selected Microsoft Windows as the Authentication Method, select or enter a Default
Domain that is presented to the device user during the authentication process. If no Default
Domain is desired, this field may be left blank.
●
If you selected Novell NDS as the Authentication Method, select or enter a Default Tree
and Default Context that is presented to the device user during the authentication process.
If no Default Tree or Default Context is desired, these fields may be left blank.
●
If you selected LDAP as the Authentication Method and want to apply that to a feature,
select HP Digital Sending Service as the Authentication Agent for that feature.
General Device configuration
This section contains information about some of the more general sub-tabs available on the
Configure Devices tab set in the Configuration Utility. Use this tab set to configure individual Digital
Sending-enabled devices. The following tabs are included in this section:
●
General subtab
●
Addressing subtab
●
Log subtab
For information about the remaining tabs, see the following topics:
●
Table 3-13 Authentication subtab — Configure Devices tab set on page 78
●
Table 3-20 Send to E-mail subtab — Configure Devices tab set on page 93
●
Fax subtab —
Configure the Device on page 102
●
Table 3-28 Send to Workflows subtab – Configure Devices tab set on page 124
80 Chapter 3 Installation and configuration ENWW