Setup and Install

Table 4-2 Device control-panel messages (continued)
Message Description and actions
Authentication failed: Error code ### Authentication failed for a reason other than incorrect user-
specified information (username and password). The
following error codes might appear in the error message.
●
201: Unexpected failure.
● 202: Authentication is not available. The service is too
busy to accept the authentication request.
●
203: Authentication is not supported.
● 204: Encryption is not supported.
●
205: Invalid parameter
●
206: Invalid LDAP logon method (the LDAP server does
not support this logon method.)
●
207: Unexpected LDAP failure occurred, either because
the LDAP server failed or the connection is bad.
●
208: The LDAP server not available; it either is not a
server or is not running LDAP.
●
209: The LDAP server is too busy.
●
210: Invalid LDAP username because the user does not
have access to the LDAP server.
●
211: Invalid LDAP user password
●
212: Invalid LDAP user credentials
● 213: Invalid LDAP user domain
●
214: Invalid LDAP privileges because the user does not
have permission to read from the LDAP database.
●
215: Invalid LDAP user record because the user does
not have an entry in the LDAP database.
● 216: Invalid LDAP container because the search root is
invalid .
●
217: Invalid LDAP name attribute
●
218: Invalid LDAP e-mail-name attribute
●
219: Invalid fax attribute
●
220: Invalid LDAP display-name attribute
● 221: No e-mail address at the specified attribute
●
222: Tested user does not have an account on the
domain
ENWW
Control panel messages
141