Setup and Install

8. Under Scan Settings, select the settings for the scanned file. These should be the settings that
the third-party software program that processes the file requires.
9. Click OK to save the workflow form.
10. Click Apply to save the settings on the Workflow tab.
Configure the Device
The Send to Workflows subtab is shown in the following illustration.
Figure 3-41 Send to Workflows subtab in the Configure Devices tab set
1
2
Table 3-28 Send to Workflows subtab – Configure Devices tab set
Callout Component Description
1 Enable Send to
Workflows
Click to select the Enable Send to Workflows check box.
2 Workflow Group Select a workflow group from the drop-down menu.
Configure the device to use Send To Workflows
1. Click to select the Enable Send to Workflows check box on the Send To Workflows tab on
the Device Configuration tab set.
2. Select a workflow from the Workflow Group drop-down menu.
3. Click Apply.
124 Chapter 3 Installation and configuration ENWW