Setup and Install

Table 3-22 Fax tab — LAN fax (continued)
Callout Component Description
6 Input Settings Configure the following input settings.
● Notification
●
Error correction mode
●
Notification timeout (minutes)
7 Output Settings Configure the following output settings.
● Transmission speed
●
Cover page
To configure LAN fax
Follow these instructions to set up faxing from the device by using the network LAN fax service.
1. On the DSS server, open the Configuration Utility and click the Fax tab.
2. Select LAN fax from the Fax Send Method drop-down list.
3. Select the LAN fax software product name from the Third Party LAN Fax Product drop-down
menu.
NOTE: If you are unsure about whether the product supports notification, select the Generic
LAN fax product without notification support option from the drop-down menu.
4. Select the Network Type from the drop-down menu.
5. Type in the network path in the UNC Folder Path, or click Browse to select the network folder
that the fax software uses.
6. Complete the Windows Domain section, if required. Then click Verify Folder Access to test
the credentials and verify access to the folder.
7. Complete the Dialing Settings section by typing in the values you want to use in the Maximum
Retry Attempts and Retry Interval (minutes) text boxes.
8. Complete the Input Settings section by selecting the values you want to use in the Notification
and Error Correction Mode drop-down menus. Type in the value you want to use in the
Notification Timeout (minutes) text box.
9. Complete the Output Settings section by selecting the values you want to use in the
Transmission Speed and Cover Page drop-down menus.
10. Click Apply to save the LAN fax settings.
ENWW
Configuration
101