Administrator's Guide

Table 3-24 Analog fax option — Fax subtab on the Configure Devices tab set — 1 of 2
Callout Component Description
1 Enable Fax Send Click to select this check box to enable the Fax Send for the device.
2 Enable Fax Receive Click to select this check box to enable the Fax Receive for the device.
3 Fax Send Select the Fax Send method from the drop-down menu.
4 Fax Dialing Settings Use the following settings to configure fax dialing at the device.
●
Fax Dial Volume. Select from the drop-down menu.
● Dialing Mode. Select from the drop-down menu.
● Dialing Prefix. Type the dialing prefix in the text box.
●
Redial Interval. Select from the drop-down menu.
● Redial on No Answer. Select from the drop-down menu.
● Redial on Busy. Select from the drop-down menu.
● Detect Dial Tone. Click the check box to select.
5 Fax Send Settings Use the following settings to configure fax send settings at the device.
● Error Correction Mode. Select from the drop-down menu.
●
Fax Header. Select from the drop-down menu.
● Enable JBIG Compression. Click the check box to select.
6 Default Send Notification
Settings
The Default Send Notification Settings are a part of the Common Job
Settings group. The e-mail address associated with a user's account is
used for notification when a user signs in at the device. If not signed, the
user must enter an e-mail address before notification is sent. The device
must also be set up to use an SMTP server.
Use the following settings to configure the Default Send Notification
Settings at the device.
● Condition on Which to Notify. Select from the drop-down menu.
●
Method Used to Deliver Notification. Select from the drop-down
menu.
● Include Thumbnail. Click the check box to select.
7 Scan Settings The Scan Settings are a part of the Common Job Settings group. Click to
select the Resolution from the drop-down menu.
8 Billing Codes Billing codes are used to track faxes sent from the device. If billing codes
are on, a message will appear every time a fax is sent unless users are not
allowed to edit the billing code.
● Default Billing Code. Type into the text box.
● Minimum Length. Type into the text box.
●
Allow users to edit billing code. Click the check box to select.
84 Chapter 3 Installation and configuration ENWW