Administrator's Guide

3. To start a conversation with the SMTP gateway, type HELO <smtp gateway> and then press
Enter. Note that the response contains a list of attributes as well as the type of SMTP gateway
that you are communicating with.
4. To send an e-mail, type mail from: <your e-mail address> and then press Enter.
5. Type rcpt to: <your e-mail address> and then press Enter.
6. Type subject: This is a test message.
7. Type data: and then press Enter.
8. Type what you want to go into the body of the message.
9. To send the message, type a period (".") and then press Enter.
10. Type quit and then press Enter to end the telnet session.
The test e-mail message should appear in the sender's inbox in a few seconds.
If the sender does not receive the e-mail message, the SMTP server might not be relaying e-mail.
Contact the network administrator.
NOTE: Versions of DSS earlier than 4.3 do not support authenticated SMTP.
ENWW Configuration 71