Update Manual

4 Important HP Media Center PC Updates
3 Continue using the wizard until finished, and then
either close or minimize Media Center.
4 Right-click a free area of the Windows desktop and
choose Properties.
5 Click the Settings tab, and then click the
Advanced button on that tab.
6 Select the GeForce 6600 or the ATI Displays
tab, depending on your PC model. If you have a
GeForce 6600 tab, follow the “Changing the
display for a GeForce 6600 graphics card”
procedure. If you have an ATI Displays tab, follow
the “Changing the display for a GeForce 6600
graphics card” procedure.
Changing the display for a
GeForce 6600 graphics card
1 Follow the “Using Media Center Setup Wizard for
Optional Setup of Your TV Display” procedure on
page 3.
2 Click the GeForce 6600 tab.
3 Click nView Display Settings.
4 Select the Device Settings button, and then you
can select the various screen adjustment settings.
5 Click Apply and then click OK.
6 Click OK again to close the window.
Changing the display for an ATI
graphics card
1 Follow the “Using Media Center Setup Wizard for
Optional Setup of Your TV Display” procedure on
page 3.
2 Click the ATI Displays tab.
3 Click the TV button (the small bar above the TV
icon). The TV Properties window opens. (Your TV
must be connected to the system.)
NOTE: You may need to click the On button (at the
left corner of the TV button bar) to make the On
button green, and then click Apply.
4 Click the Adjustments tab.
5 Adjust the screen position or screen size, and then
click Apply.
6 Click OK as needed to close the windows.
Correcting Your HDTV
Display for Overscan
Overscan is when the outer edges of the TV signal or
picture are cut off by the display. This may happen on
some CRT-based HDTVs. If the resolution for the output
to the TV is set higher than the TV can support, the
picture does not display correctly.
NOTE: This procedure is only valid for displays
connected to a GeForce 6600 graphics card.
To make the full desktop or picture appear on your
HDTV display:
1 Right-click a clear area of the Windows desktop
and then click Properties.
2 Click the Settings tab, and then click the
Advanced button.
3 Click the GeForce 6600 tab.
4 Click nView Display Settings.
5 Select Clone from the nView Display Mode drop-
down menu, and then click Apply.
6 Click the Device Settings button, choose Select
TV format, and then click Advanced.
7 On the TV settings page, click HDTV Desktop.
8 Make sure the “Use underscan to show the entire
Windows desktop” button is highlighted.
9 Put a check in the “Remembering preference for the
selected format,” check box, and then click OK.
10 Select Yes to readjust your resolution and then
click OK.
11 Click OK, OK, and then OK again to return to the
desktop. All or most of the desktop should be
displayed.