McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Quick Setup Instructions (A8001-90002, July 2005)

Page 3
McDATA 4Gb SAN Switch for HP p-Class BladeSystem quick setup instructions
5. Select the switch in the graphic window of the Topology display.
6. Select Switch > Network Properties.
7. Change the IP Address, Subnet Mask, and Gateway
settings to reflect your desired network configuration in the
Network Properties dialog, and click OK.
8. Close the McDATA Web Server application. The switch is now
ready to be managed through your network.
9. To launch the McDATA Web Server application once your
configured switch is connected to the network, repeat steps 1-4
using the switch's newly configured IP address.
SAN Switch external ports
Table 1 External port numbers
SAN Switch LED descriptions
The following diagram and tables describe the location,
color-coding, and activity of the LEDs on the SAN Switch.
Table 2 Ethernet LED patterns
Table 3 Heartbeat LED patterns
Port number Description
0FC switch port 0
9FC switch port 9
Ethernet connector
port (RJ-45)
0
9
Maintenance button
Power LED
Heartbeat LED
System fault LED
Ethernet status LED
Ethernet activity LED
Port logged-in
LEDs
Port activity
LEDs
LED name,
location
LED color Status of
hardware
Recommended
action
Ethernet activity
LED located at
upper left
corner of
Ethernet port
Off No traffic No action
Blinking green Traffic present No action
Ethernet status
LED located at
lower left
corner of
Ethernet port
Off No link Verify cable is
connected
Steady green Link is valid No action
required
LED name,
location
LED color Status of
Hardware
Recommended
action
Heartbeat LED
located upper
right in cluster
of LEDs below
the Ethernet
port
Off Switch is off Verify switch is
on
Steady green Switch is in
maintenance
mode
Reset the
switch to return
to normal
operation
Flashing green
(on 1/2
second, off
1/2 second)
Switch is
powered on
No action
required
Flashing green
(on twice for
1/2 second,
off 2 seconds;
twice as fast
as normal
blink)
Internal
firmware
failure
Gather
logging data,
call support
before
resetting the
switch
Flashing green
(on three times
for 1/2
second, off 2
seconds; twice
as fast as
normal blink)
Power On Self
Test failure or
system failure
Contact
technical
support
Flashing green
(on four times
for 1/2
second, off 2
seconds; twice
as fast as
normal blink)
Configuration
file system
error
Restore the
switch
configuration
Flashing green
(on 1/2
second five
times, off 2
seconds; twice
as fast as
normal blink)
Over
temperature
condition
Diagnose and
correct cooling
problem