McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 65
Managing zone sets
Managing zone sets consists of the following tasks:
• Create a zone set, page 65
• Delete a zone set, page 65
• Rename a zone set, page 65
• Add zones to a zone set, page 65
• Remove zones from a zone set, page 65
• Activate a zone set, page 66
• Deactivate a zone set, page 66
All of these tasks except ”Activate a zone set” and ”Deactivate a zone set” require an Admin session and
a Zoning Edit session.
See the ”Zoneset command” on page 226.
Create a zone set
Enter the Zoneset Create command to create a new zone set as shown in the following example:
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) #> zoning edit
McDATA4GbSAN (admin-zoning) #> zoneset create zoneset_1
McDATA4GbSAN (admin-zoning) #>zoning save
Delete a zone set
Enter the Zoneset Delete command to delete a zone set as shown in the following example:
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) #> zoning edit
McDATA4GbSAN (admin-zoning) #> zoneset delete zoneset_1
McDATA4GbSAN (admin-zoning) #>zoning save
Rename a zone set
Enter the Zoneset Rename command to rename a zone set as shown in the following example:
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) #> zoning edit
McDATA4GbSAN (admin-zoning) #> zoneset rename zoneset_old zoneset_new
McDATA4GbSAN (admin-zoning) #>zoning save
Add zones to a zone set
Enter the Zoneset Add command to add a zone to a zone set as shown in the following example:
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) #> zoning edit
McDATA4GbSAN (admin-zoning) #> zoneset add zoneset_1 zone_1 zone_2
Remove zones from a zone set
Enter the Zoneset Remove command to remove zones from a zone set as shown in the following
example:
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) #> zoning edit
McDATA4GbSAN (admin-zoning) #> zoneset remove zoneset_1 zone_1 zone_2
McDATA4GbSAN (admin-zoning) #>zoning save