McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

52
Port binding
Port binding establishes up to 32 switches or devices that are permitted to log in to a particular switch port.
Switches or devices that are not among the 32 are refused access to the port. You apply port binding
changes by modifying the switch configuration as described in ”Modify a switch configuration” on
page 35.
Enter the Show Config Security Portbinding command to display the port binding configuration
for all ports as shown in the following example:
McDATA4GbSAN #> show config security port
Configuration Name: default
-------------------
Port Binding Status WWN
---- -------------- ---
Ext:0 False 10:20:30:40:50:60:70:80
Ext:9 False 10:20:30:40:50:60:70:81
Int:1 False No port binding entries found.
Int:2 False No port binding entries found.
Int:3 False No port binding entries found.
Int:4 False No port binding entries found.
Int:5 False No port binding entries found.
Int:6 False No port binding entries found.
Int:7 False No port binding entries found.
Int:8 False No port binding entries found.
Enter the Set Config Security Portbinding command within an Admin session to enable port
binding for the selected port and to specify the WWNs of the authorized ports/devices. The following
example enables port binding on port 0 and specifies two device WWNs.
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) config edit
McDATA4GbSAN (admin-config) #> set config security portbinding 0
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
PortBindingEnabled (True / False)[False] true
WWN (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f9
WWN (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f8
WWN (N=None / WWN)[None ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command
See the ”Show Config Security command” on page 178
See the ”Set Config Security Portbinding command” on page 150.