McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 51
Modifying port operating characteristics
You can make permanent or temporary changes to port operating characteristics. You make permanent
changes by modifying the switch configuration as described in ”Modify a switch configuration” on
page 35. These changes are saved in the active configuration and are preserved across switch or port
resets. The Set Port command makes temporary changes that apply until the next port or switch reset, or
until you activate a configuration.
The following example permanently changes the port 0 administrative state to Offline:
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) #> config edit
McDATA4GbSAN (admin-config) #> set config port 0
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the port being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
Configuring Port Number: 0
------------------------
AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online] 2
LinkSpeed (1=1Gb/s, 2=2Gb/s, 4=4Gb/s, A=Auto) [Auto ]
PortType (GL / G / F / FL) [GL ]
SymPortName (string, max=32 chars) [Port0 ]
ALFairness (True / False) [False ]
DeviceScanEnable (True / False) [True ]
ForceOfflineRSCN (True / False) [False ]
ARB_FF (True / False) [False ]
InteropCredit (decimal value, 0-255) [0 ]
FANEnable (True / False) [True ]
AutoPerfTuning (True / False) [False ]
LCFEnable (True / False) [False ]
MFSEnable (True / False) [False ]
VIEnable (True / False) [False ]
MSEnable (True / False) [True ]
NoClose (True / False) [False ]
PDISCPingEnable (True / False) [True ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
The following example temporarily changes the port 0 administrative state to Down:
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) #> set port 0 state down
See the ”Set Config Port command” on page 146.
See the ”Set Port command” on page 162.