McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 47
5Port configuration
This section describes the following port configuration tasks:
• Displaying port information, page 47
• Modifying port operating characteristics, page 51
• Port binding, page 52
• Resetting a port, page 53
• Configuring port threshold alarms, page 53
• Testing a port, page 55
Displaying port information
You can display the following port information:
• Port configuration parameters, page 47
• Port operational information, page 48
• Port threshold alarm configuration parameters, page 49
• Port performance, page 50
Port configuration parameters
Enter the Show Config Port command to display the port configuration parameters. These parameters
determine the operational characteristics of the port. Refer to Table 19 for a description of these
parameters.
McDATA4GbSAN #> show config port 9
Configuration Name: default
-------------------
Port Number: 9
------------
AdminState Online
LinkSpeed Auto
PortType GL
SymbolicName Port9
ALFairness False
DeviceScanEnabled True
ForceOfflineRSCN False
ARB_FF False
InteropCredit 0
FANEnabled True
AutoPerfTuning True
MSEnabled True
NoClose False
PDISCPingEnabled True
MSEnabled True
NoClose False
PDISCPingEnabled True
See the ”Show Config Port command” on page 177.