McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 37
The restore process replaces all configuration information on the switch and afterwards the switch is
automatically reset. If the restore process changes the IP address, all management sessions are terminated.
Use the Set Setup System command to return the IP configuration to the values you want. To restore
the switch, open a Telnet session (a new IP address may be required), then enter the Config Restore
command from within an Admin session as shown in the following example:
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) #> config restore
The switch will be reset after restoring the configuration.
Please confirm (y/n): [n] y
Alarm Msg: [day month date time year][A1005.0021][SM][Configuration is
being restored - this could take several minutes !]
Alarm Msg: [day month date time year][A1000.000A][SM][The switch will be
reset in 3 seconds due to a config restore]
McDATA4GbSAN (admin) #>
Alarm Msg: [day month date time year][A1000.0005][SM][The switch is being
reset]
Good bye.
See the ”Config command” on page 100.