McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 33
Managing switch services
You can configure your switch to suit the demands of your environment by enabling or disabling a variety
of switch services. You manage the switch services using the Show Setup Services and
Set Setup Services commands. See Table 27 for a description of the switch services.
Enter the Show Setup Services command to display the current switch service status as shown in the
following example:
McDATA4GbSAN #> show setup services
System Services
-----------------------------
TelnetEnabled True
SSHEnabled False
GUIMgmtEnabled True
SSLMgmtEnabled False
EmbeddedGUIEnabled True
SNMPEnabled True
NTPEnabled True
CIMEnabled True
FTPEnabled True
MgmtServerEnabled True
See the ”Show Setup Services command” on page 204.
Enter the Set Setup Services command within an Admin session to configure the switch services as
shown in the following example:
McDATA4GbSAN (admin) #> set setup services
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
*Warning: If services are disabled, the connection to the switch may be lost.
TelnetEnabled (True / False) [True ]
SSHEnabled (True / False) [False]
GUIMgmtEnabled (True / False) [True ]
SSLMgmtEnabled (True / False) [False]
EmbeddedGUIEnabled (True / False) [True ]
SNMPEnabled (True / False) [True ]
NTPEnabled (True / False) [False]
CIMEnabled (True / False) [True ]
FTPEnabled (True / False) [True ]
MgmtServerEnabled (True / False) [True ]
Do you want to save and activate this services setup? (y/n): [n]
See the ”Set Setup Services command” on page 165.