McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 25
The Show Setup System command displays the switch network configuration as shown in the following
example:
McDATA4GbSAN #> show setup system
System Information
------------------
EthNetworkEnable True
EthNetworkDiscovery Static
EthNetworkAddress 10.20.11.32
EthNetworkMask 255.255.252.0
EthGatewayAddress 10.20.8.254
AdminTimeout 30
InactivityTimeout 0
LocalLogEnabled True
RemoteLogEnabled False
RemoteLogHostAddress 10.0.0.254
NTPClientEnabled True
NTPServerAddress 51.68.85.102
EmbeddedGUIEnabled True
See the ”Show Setup System command” on page 206.
Configuring the ethernet port
Configure the switch Ethernet port using the Set Setup System command within an Admin session.
The following example configures a new IP address, subnet mask, and gateway address:
McDATA4GbSAN (admin) #> set setup system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
EthNetworkDiscovery (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) [Static ]
EthNetworkAddress (dot-notated IP Address) [10.0.0.1 ]10.20.30.40
EthNetworkMask (dot-notated IP Address) [255.255.255.0]255.0.0.0
EthGatewayAddress (dot-notated IP Address) [10.0.0.254 ]10.20.30.254
AdminTimeout (dec value 0-1440 minutes, 0=never) [30 ]
InactivityTimeout (dec value 0-1440 minutes, 0=never) [0 ]
LocalLogEnabled (True / False) [True ]
RemoteLogEnabled (True / False) [False ]
RemoteLogHostAddress (dot-notated IP Address) [10.0.0.254 ]
NTPClientEnabled (True / False) [False ]
NTPServerAddress (dot-notated IP Address) [10.0.0.254 ]
EmbeddedGUIEnabled (True / False) [True ]
See the ”Set Setup System command” on page 169.