McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

208
Show Switch command
Description Displays switch operational information.
Authority None
Syntax
show switch
Notes Table 33 describes the switch operational parameters.
Table 33 Switch operational parameters
Parameter Description
SymbolicName Descriptive name for the switch
SwitchWWN Switch WWN
BootVersion PROM boot version
CreditPool Not applicable
DomainID Domain ID of the switch
FirstPortAddress FC address of switch port 0
FlashSize - MBytes Size of the flash memory, in megabytes
LogFilterLevel Event severity level used to record events in the event log
MaxPorts Number of ports available on the switch
NumberOfResets Number of times the switch has been reset over its service life
ReasonForLastReset Event or action that caused the last reset
ActiveImageVersion -
build date
Active firmware image version and build date
PendingImageVersion -
build-date
Firmware image version and build date that is pending. This image will
become active at the next reset or power cycle.
ActiveConfiguration Name of the switch configuration that is in use
AdminState Administrative state of the switch
AdminModeActive Admin session status (True/False)
BeaconOnStatus Beacon status as set by the Set Beacon command (True/False)
OperationalState Operational state of the switch (Online, Offline, Diagnostics)
PrincipalSwitchRole Role of the switch. This parameter indicates the principal switch (True) or
not (False).
BoardTemp (1) - Degrees
Celsius
Internal switch temperature at circuit board sensor 1
SwitchDiagnosticsStatus Results of the POST (Passed/Failed)
SwitchTemperatureStatus Switch temperature status (Normal/Warning/Failure)