McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

190
Show Media command
Description Displays transceiver operational and diagnostic information for one or more ports.
Authority None
Syntax
show media
[port_number]
all
installed
Operands
[port_number]
The external port for which to display transceiver information. External ports are numbered 0 and
9.
all
Displays transceiver information for all ports.
installed
Displays transceiver information for all ports that have transceivers installed.
Notes Table 30 describes the transceiver information in the Show Media display.
Table 30 Transceiver Information
Information Type Description
MediaType Fibre Channel specification or one of the following:
• NotInstalled–transceiver is not installed.
• Unknown–transceiver does not have a serial ID.
• NotApplicable–transceiver is not needed.
MediaVendor Vendor name
MediaPartNumber Vendor media part number
MediaRevision Vender media revision level
MediaSerialNumber Vendor media serial number
MediaSpeeds Transmission speed capabilities
Temp Temperature in degrees Celsius
Voltage Supply voltage in Volts. The range is 0–6.55.
Tx Bias Transmitter laser bias current in milliAmps. The range is 0–655.
Tx Power Transmitter coupled output power in milliWatts. The range is 0–6.55.
Rx Power Received optical power in milliWatts. The range is 0–6.55.
Value Measured value.
Status State associated with the measured value:
• Normal: Value is in the normal operating range.
• HighAlarm: Value exceeds the high alarm threshold.
• HighWarning: Value exceeds the high warning threshold.
• LowWarning: Value is less than the low warning threshold.
• LowAlarm: Value is less than the low alarm threshold.
HighAlarm Vendor specified threshold above which an alarm is issued.