McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

174
Show Alarm command
Description Displays the alarm log and session output stream display setting.
Authority None
Syntax
show alarm settings
Operands
settings
Displays the status of the parameter that controls the display of alarms in the session output
stream. This parameter is set using the Set Alarm command.
Notes The alarm log is cleared when the switch is reset or power cycled.
Examples The following is an example of the Show Alarm Settings command:
McDATA4GbSAN #> show alarm settings
Current settings for alarm
--------------------------
display ON
See also Set Alarm command, page 144
Show Log command, page 186