McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

168
TrapCommunity Trap community password that authorizes an SNMP agent to receive traps.
This is a write-only field. The value on the switch and the SNMP
management server must be the same. The trap community password can
be up to 32 characters. The pound (#), semicolon (;), and comma (,)
characters are not permitted. The default is public.
AuthFailureTrap Enables (True) or disables (False) the generation of traps in response to
trap authentication failures. The default is False.
Table 28 SNMP configuration settings (Continued)
Entry Description
Examples The following is an example of the Set Setup SNMP command:
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) #> set setup snmp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Trap Severity Options
---------------------
unknown,emergency,alert,critical, error, warning, notify, info, debug, mark
SNMPEnabled (True / False) [True ]
Contact (string, max=64 chars) [<sysContact undefined]
Location (string, max=64 chars) [sysLocation undefined]
Trap1Address (dot-notated IP Address) [10.20.71.15 ]
Trap1Port (decimal value) [162 ]
Trap1Severity (see allowed options above) [warning ]
Trap1Version (1 / 2) [2 ]
Trap1Enabled (True / False) [False ]
Trap2Address (dot-notated IP Address) [0.0.0.0 ]
Trap2Port (decimal value) [162 ]
Trap2Severity (see allowed options above) [warning ]
Trap2Version (1 / 2) [2 ]
Trap2Enabled (True / False) [False ]
Trap3Address (dot-notated IP Address) [0.0.0.0 ]
Trap3Port (decimal value) [162 ]
Trap3Severity (see allowed options above) [warning ]
Trap3Version (1 / 2) [2 ]
Trap3Enabled (True / False) [False ]
Trap4Address (dot-notated IP Address) [0.0.0.0 ]
Trap4Port (decimal value) [162 ]
Trap4Severity (see allowed options above) [warning ]
Trap4Version (1 / 2) [2 ]
Trap4Enabled (True / False) [False ]
Trap5Address (dot-notated IP Address) [0.0.0.0 ]
Trap5Port (decimal value) [162 ]
Trap5Severity (see allowed options above) [warning ]
Trap5Version (1 / 2) [2 ]
Trap5Enabled (True / False) [False ]
ReadCommunity (string, max=32 chars) [public ]
WriteCommunity (string, max=32 chars) [private ]
TrapCommunity (string, max=32 chars) [public ]
AuthFailureTrap (True / False) [False ]
See also Show Setup Snmp command, page 205