McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

164
AccountingServer Enable (True) or disable (False) this server for auditing of activity during
a user session. When enabled, user activity is audited whether
UserAuthServer is enabled or not. The default is False.
The accounting server UDP port number is the ServerUDPPort value
plus 1. The default is 1813.
Timeout Number of seconds to wait to receive a response from the RADIUS
server before timing out. The default is 2.
Retries Number of retries after the first attempt to establish communication with
the RADIUS server fails. The default is 0.
SignPackets Enable (True) or disable (False) the use of sign packets to protect the
RADIUS server packet integrity. The default is False.
Secret 32-byte hex string or 16-byte ASCII string used as a password for
authentication purposes between the switch and the RADIUS server.
Table 26 RADIUS service settings (Continued)
Entry Description
Examples The following is an example of the Set Setup RADIUS command:
McDATA4GbSAN (admin) #> set setup radius
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
DeviceAuthOrder (1=Local, 2=Radius, 3=RadiusLocal) [Local]
UserAuthOrder (1=Local, 2=Radius, 3=RadiusLocal) [Local]
TotalServers (decimal value, 0-5) [1 ]
Server: 1
ServerIPAddress (dot-notated IP Address) [10.20.11.8]
ServerUDPPort (decimal value) [1812 ]
DeviceAuthServer (True / False) [True ]
UserAuthServer (True / False) [True ]
AccountingServer (True / False) [False ]
Timeout (decimal value, 10-30 secs) [10 ]
Retries (decimal value, 1-3, 0=None) [0 ]
SignPackets (True / False) [False ]
Secret (32 hex or 16 ASCII char value) [******** ]
Do you want to save and activate this radius setup? (y/n): [n]
See also Show Setup Radius command, page 203