McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 163
Set Setup Radius command
Description Configures RADIUS servers on the switch.
Authority Admin session
Syntax
set setup radius
This command prompts you in a line-by-line fashion to configure RADIUS servers for user account
and device authentication. Table 26 describes the RADIUS server configuration settings.
Table 26 RADIUS service settings
Entry Description
DeviceAuthOrder
IMPORTANT: This setting is valid only with the SANtegrity
Enhanced PFE key
Authenticator priority for devices:
• Local—Authenticate devices using only the local security database.
This is the default.
• Radius—Authenticate devices using only the security database on the
RADIUS server.
• RadiusLocal—Authenticate devices using the RADIUS server security
database first. If the RADIUS server is unavailable, then use the local
switch security database.
UserAuthOrder Authenticator priority for user accounts:
• Local—Authenticate users using only the local security database. This
is the default.
• Radius—Authenticate users using only the security database on the
RADIUS server.
• RadiusLocal—Authenticate users using the RADIUS server security
database first. If the RADIUS server is unavailable, then use the local
switch security database.
TotalServers Number of RADIUS servers to configure during this session. Setting
TotalServers to 0 disables all RADIUS authentication. The default is 0.
ServerIPAddress IP address of the RADIUS server. The default is 10.0.0.1.
ServerUDPPort User Datagram Protocol (UDP) port number on the RADIUS server. The
default is 1812.
DeviceAuthServer
IMPORTANT: This setting is valid only with the SANtegrity
Enhanced PFE key
Enable (True) or disable (False) this server for device authentication. The
default is False.
UserAuthServer Enable (True) or disable (False) this server for user account
authentication. A user authentication RADIUS server requires a secure
management connection (SSL). The default is True.