McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 161
Set Pagebreak command
Description Specifies how much information is displayed on the screen at one time. This command is useful for
disabling page breaks to allow command scripts to run without interruption.
Authority None
Syntax
pagebreak [state]
Operands [state]
[state] can be one of the following:
on
Limits the display of information to 20 lines at a time. The page break function affects the
following commands:
• Show Alarm, Show Log
• Zone List, Zone Members
• Zoneset List, Zoneset Zones
• Zoning Active, Zoning List
off
Allows continuous display of information without a break. This is the default.
Examples The following is an example of the Set Pagebreak command:
McDATA4GbSAN #> set pagebreak on
McDATA4GbSAN $> set pagebreak off
See also Show Pagebreak command, page 194