McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 153
Set Config Switch command
Description Sets the switch configuration parameters. The changes you make with this command are not retained
when you reset or power cycle the switch unless you save them using the Config Save command.
Authority Admin session and a Config Edit session
Syntax
set config switch
This command initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value. For each parameter,
enter a new value or press Enter to accept the current value shown in brackets. Table 23 describes
the switch configuration parameters.
Table 23 Set Config Switch parameters
Parameter Description
AdminState Switch administrative state:
• Online—Activates and prepares the ports to send data. This is the
default.
• Offline—Prevents the ports from receiving signal and accepting a
device login.
• Diagnostics—Prepares the ports for testing and prevents the ports
from accepting a device login.
• Down—Disables the ports by removing power from the port lasers.
BroadcastEnabled Enables (True) or disables (False) forwarding of broadcast frames. The
default is True.
InbandEnabled Inband management. Enables (True) or disables (False) the ability to
manage the switch over an ISL. The default is True.
FDMIEnabled Fabric Device Monitoring Interface. Enables (True) or disables (False) the
monitoring of target and initiator device information. The default is True.
FDMIEntries The number of device entries to maintain in the FDMI database. Enter a
number from 0–1000. The default is 1000.
DefaultDomainID Default domain ID. The default is 97.
DomainIDLock Prevents (True) or allows (False) dynamic reassignment of the domain ID.
The default is False.
SymbolicName Descriptive name for the switch of up to 32 characters. The pound (#),
semicolon (;), and comma (,) characters are not permitted. The default is
McDATA4GbSAN.
R_A_TOV Resource Allocation Timeout Value. The number of milliseconds the
switch waits to allow two ports to allocate enough resources to establish
a link. The default is 10000.
E_D_TOV Error Detect Timeout Value. The number of milliseconds a port is to wait
for errors to clear. The default is 2000.
PrincipalPriority The priority used in the FC-SW-2 principal switch selection algorithm. 1 is
high, 255 is low. The default is 254.
ConfigDescription Switch configuration description of up to 32 characters. The pound (#),
semicolon (;), and comma (,) characters are not permitted. The default is
Default Config.