McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 151
Set Config Security Switchbinding command
Description Configures a list of device WWNs that are permitted to log in to the switch. The changes you make
with this command are not retained when you reset or power cycle the switch unless you save them
using the Config Save command.
Authority Admin session and a Config Edit session
Syntax set config security switchbinding
This command initiates an editing session in which to change the binding configuration for the
switch. The system displays each parameter one line at a time and prompts you for a value. For each
parameter, enter a new value or press Enter to accept the current value shown in brackets. Enter q or
Q to end the editing session. Table 22 describes the Set Config Security Switchbinding
parameters.
Table 22 Set Config Security Switchbinding parameters
Parameter Description
SwitchBindingEnable Enables (True) or disables (False) switch binding.
SwitchBindingState Determines what types of connections to enforce:
• Allports—All switches and devices not on the WWN list are refused
login to the switch.
• EPorts—All switches not on the WWN list are not allowed to log in.
There is no enforcement on devices.
• FPorts—All devices not on the WWN list are refused login to the
switch. There is no enforcement on other switches.
WWN WWN list.
• N = None—Removes an existing WWN from the list.
• WWN = 16-character hexadecimal device or switch WWN with the
format xx:xx:xx:xx:xx:xx:xx:xx.